Forum Messages

Forum Home Page

Date Name Message
03/02/2005 21:52:29   Peter klos   Hi All
I have just rebuilt my engine which included new clutch /slave/master cylinders .
When I depress the clutch fully I can feel the release arm hit the pressure plate
I have removed the engine and can see the top end of the release bearing arm has been hitting part of the pressure plate
Could someone advise

I am located in Australia and appreciate the previous messages on this forum
Peter
 
04/02/2005 08:01:19   Richard   Double check you have the right clutch/master combination ie bore sizes. A lot of the clutch kits are poor and can need some setting up. There is a dimension in the service books from flywheel face to the pressure plate release bearing face (this is from memory, so double check that it is from these areas). You may need to put washers between the clutch pressure plate and flywheel to alter the initial position of the clutch release bearing face on the pressure plate.  
04/02/2005 08:29:29   Richard   One other thing is you can space the clutch cylinder off the bracket.  
04/02/2005 11:26:57   Peter klos   Thanks Richard
Did try to space the clutch cylinder off the bracket but made it worse.
the new clutch plate is quite a lot thicker then the old one and think I need to make some shins between the pressure plate and the fly wheel
Any idea of the dimension (dont have much technical info)on the V4

regards Peter  
04/02/2005 12:34:25   Richard   I will have a look over the weekend. Good to see someone from Australia on the form, I have some friends from there.  


Post Reply

Name
E-Mail
Reply